How to Check Fuel Injector Resistance with a Multimeter

Using a Multimeter to Test Fuel Injector Resistance Ohms. Learn how to check fuel injectors to make sure they are working. You use a multimeter on the resistance settings and measure the ohms of the injector. All injectors should be within .5 ohms of each other. If an injector is out of the resistance specification, that injector is bad. Symptoms of bad injectors are a check engine light with codes P0300 through P0308, misfiring, hesitation, poor fuel economy, stalling, and a poor idle. Using a Screwdriver to test fuel injectors (EASY): https://www.youtube.com/watch?v=tA_E6X4ISgQ How to test Fuel Pressure : https://www.youtube.com/watch?v=_oXLUqE4Sf0 How to Test Spark Plug Wires: https://www.youtube.com/watch?v=4_EFGAFxi1w **If the video was helpful, remember to give it a "thumbs up" and consider subscribing. New videos every Thursday** -Website: https://www.ChrisFixed.com -Facebook: https://www.facebook.com/chrisfix8 -Twitter: https://twitter.com/ChrisFixed -Instagram: https://instagram.com/chrisfixit -Subscribe Here: http://www.youtube.com/subscription_center?add_user=paintballoo7 -YouTube Channel: https://www.youtube.com/ChrisFix Disclaimer: Due to factors beyond the control of ChrisFix, I cannot guarantee against improper use or unauthorized modifications of this information. ChrisFix assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. Use this information at your own risk. ChrisFix recommends safe practices when working on vehicles and or with tools seen or implied in this video. Due to factors beyond the control of ChrisFix, no information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. Any injury, damage, or loss that may result from improper use of these tools, equipment, or from the information contained in this video is the sole responsibility of the user and not ChrisFix.