Reclaimed Wine Rack | Build It | Ask This Old House

Ask This Old House general contractor Tom Silva and host Kevin O’Connor build a wine rack out of a reclaimed beam. SUBSCRIBE to This Old House: http://bit.ly/SubscribeThisOldHouse Time: 6-7 hours Cost: $500 Skill Level: Moderate Tools List for Building a Wine Rack: Miter saw Surface planer Clamps Table saw Metal detector Router Palm sander Drill Pocket hole jig Mortising drill Air compressor Brad nailer Block plane Shopping List: Preferred lumber for base, top, and rails Wood glue 150 grit sandpaper Wood screws Floating tenons Brad nails Steps: 1. If using old wood, start by checking the pieces for old nails using a metal detector and pull them out before they damage any of the tools for the project. 2. Start by cutting pieces for the top of the wine rack to size with the miter saw. 3. Fasten the top of the wine rack together using wood glue and clamps. While the glue dries, work on the rest of the rack. 4. Rip the legs down to 2”x2” using the table saw. Then, run all the legs through the surface planer as well. Turn each leg to ensure all four sides are smooth, but also stay square. 5. Use the router to cut stop dados in the legs to accept the wood for the back and sides. 6. Cut 1” stiles for the sides and back of the wine rack. Make dado cuts with the router to accept the lumber for the rails. 7. Cut the lumber being used for the rails to size using the table saw. Make rabbet cuts in the lumber using the router. 8. Give all the pieces a light sanding using the palm sander and 150 grit sandpaper. 9. Drill out pocket holes in the rails and then assemble the legs, stiles, and rails together using the dado slots. Secure all the pieces together with the pocket screws. 10. Cut the pieces for the racks down to 1x1”. Measure and mark the front and back pieces of the rack so that the dividers in the middle are evenly spaced across the rack. 11. Cut mortises for the floating tenons in the marked locations on the front and back pieces, and on the ends of the dividers. 12. Assemble the racks using wood glue and the floating tenons. 13. Secure the racks to one side using the brad nailer. Then, slide the back panel into the legs and secure those with pocket screws. 14. Add the other side to the wine rack and secure the racks to that side with the brad nailer as well. 15. To make the glass holders, cut a few pieces of wood roughly the size of the racks. Turn the angle of the table saw blade out 15 degrees and cut the wood so it has a V shape on one side. Keep the other side straight. Ease over the curved edges with a block plane. 16. Cut more pieces of wood to the same size but keep them flat on all sides. Glue those pieces to the V pieces so they become an upside down T shape. 17. Cut some support pieces the width of the wine rack. Line up all the upside down T glass holders evenly along the support pieces. Then, nail the upside down Ts to the support pieces with the brad nailer. 18. Slide the wine glass holder rack into the wine rack and secure it with more brad nails. 19. Once the top has dried, screw it onto the rest of the rack using wood screws. 20. Apply a desired finish and allow the finish to dry. Resources: The wood glue Tom used to assemble the top and some of the other pieces of the rack are manufactured by Gorilla Glue (https://www.gorillatough.com/). Build It: This Old House general contractor Tom Silva, This Old House host Kevin O’Connor, and special guests including Jimmy DiResta, take you through step-by-step DIY projects in this popular video series. From end-tables to cutting boards to wine racks to chicken coops and more, learn how to build from the best pros in the game. Segments include mention of all tools and materials needed to get the job done. Looking for more step by step guidance on how to complete projects around the house? Join This Old House Insider to stream over 1,000 episodes commercial-free. https://bit.ly/2GPiYbH   Plus, download our app for streaming full episodes to your connected TV, phone or tablet: https://bit.ly/34RYEP5 Follow This Old House and Ask This Old House: Facebook: http://bit.ly/ThisOldHouseFB Twitter: http://bit.ly/ThisOldHouseTwitter http://bit.ly/AskTOHTwitter Pinterest: http://bit.ly/ThisOldHousePinterest Instagram: http://bit.ly/ThisOldHouseIG http://bit.ly/AskTOHIG For more on This Old House and Ask This Old House, visit us at: http://bit.ly/ThisOldHouseWebsite Reclaimed Wine Rack | Build It | Ask This Old House https://www.youtube.com/user/thisoldhouse/